Mold Cleaner 2508

Mold Cleaner 2508 is a unique blend of active solvents formulated to remove build-up associated with molding thermoset resins such as polyurethanes, epoxies, polyester and vinyl esters. This cleaner will clean mold release and resin residue from steel and aluminum surfaces. Mold Cleaner 2508 does not contain chlorinated or fluorocarbon solvents.

Field tests have shown that 2508 exhibits excellent results when compared to methylene chloride or other blends of chlorinated solvents. Mold Cleaner 2508 uses ingredients which are both low in toxicity and environmental hazards and with low odor.

Application:

  • Do not use on molds heated above 150°F without proper eye and respiratory safety equipment.
  • Brush on the mold surface liberally and allow time to penetrate.
  • Allow to remain until the build-up is softened, or dissolved.
  • Wipe with a clean rag and apply a second coat and wipe after 3 minutes.
  • On molds other than steel or aluminum, test for compatibility on a small section on test panel before using.
Properties:
Product Specifications
Odor Solvent
Appearance Clear Liquid
Color Clear
% Non-Volatile None
Flash Point 100°F
Viscosity Water-like
Mold Types Aluminum & Steel
Application Brush-on

WARNING: Known to the state of CA to cause cancer, birth defects or reproductive harm - www.P65Warnings.ca.gov

Caution:
  • Use adequate protection when handling any release solvent systems.
  • Skin contact my cause dryness.
  • Wear safety glasses or their equivalent to prevent eye injury.
  • Avoid inhalation of excessive amount of solvent vapor.
Technical Service:

Technical Service specialists are available to assist you with your mold release requirements. They can recommend specific formulations, cleaning procedures, and equipment to meet the particular needs of individual customers. For technical assistance.. Contact Us